![]() ![]() If you get an error stating "Failed ato activate the printer" its a known bug in UpStudio and I have raised a request with them to get that fixed. Later 'TurnOffFan.gcode` can be used to turn off the fan and steppers. If you change the fan wiring, then remember that UP Studio doesn't switch ON and OFF the cooling fan! So you would need to remember to print TurnOnFan.gcode before issuing normal print command from UpStudio. If you want to use the fan selectively open the extruder cover and llug the FAN wire connector into the LASER contol connetor (the same white connector next to the fan connector) Slic3r gcode already handles enabling and disabling this end point as required (using M42 P15). The extruder has a pin which can be used for the other accessories (laser was proposed in their kick starter ) ![]() After the print stepper motors are switched off, so Z axis can drop and may destroy to your print!!Įvery time before you want to print initilaize your 3D printer again using the physical switch since Stepper motors are swiched off, therfore may not in the right position.Ĭetus turns on the noisy fan as soon as powered ON. Make sure the Z-axis friction holder (small white ring at bottom) is tight. This basically messes up the filament usage prediction in Slic3r, and I haven't find a way to fix it. In the Filament section update Extrusion Multiplier to 23. In Slic3r create a custom printer profile and paste start and end gcodes from the respective files Don't deduct the 0.5 mm that is required to do in Up Studio Import the Cetus configuration (in Slic3r File->Load Config, select the ini file in this thing)Įdit start.gcode replace 182.9 with the value noted in #2. If step#1 is correctly done you should get all 0 for each of the 9 points. Use the UpStudio calibration screens to calibrate z-axis. Use the instructions given by myfordboy and level the axis as far as possible. It also turns off steppers at the end of printing. Several beeps are added as well to indicate when the gcode is transimitted to printer, when the heater has reached the temperature, when the print is done, and finally when the setup is turned off. Tinyfab offer an ecosystem of electronic hardwares, for details visit: When installed, printer will NOT be compatible with Tiertime Software UP Studio and other official addons eg. I took official S3d profile, and modified it for Slic3r. Support Simplif圓D, Slic3R, Cura, Octoprint and etc. Slic3r Prusa edition has very nice support for 3d infills, and surface finishes, and has good open source community support. TierTime has officially published only Simplif圓d profile, but not for others like Cura or Slic3r. Their UpStudio supports printing gcode generated by other slicers. TierTime Cetus is a very capable printer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |